* Nemt at få sit emne af byggepladen efter printning

As a result

1 hour charge = 50 min printing

* Continue printing after power failure

Dry temperature: 50 ℃

TPM - Wash Solvent - 20L Adapter * Nemt at få sitWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 20 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs