M6 nuts: 40pcs

75mm filaments

Spectrum Filaments is one of the few manufacturers in the world to introduce the possibility of presenting individual parameters online for each individual spool produced:

Mount your new SpiderPowderSpringSteel Sheet System and start printing

Download the correct version for your operating system or you can get the executable version for Windows (easier)

TPM - Wash Solvent - 5L Wiiboox - Light 130 - Reservedele M6 nuts: 40pcsWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs